Start with the design, then verify the room
Designer drawings are the starting point, but the actual room controls the installation. Wall positions, floor level, corners, service points and appliance clearances should be checked before the cabinet run is committed.
Establish the cabinet geometry first
Base, wall and tall units need a consistent datum, level and line. Small errors at the first cabinet can become large alignment problems at the end of a run.
Fillers and end panels are functional details
Fillers are not only decorative. They can provide door and drawer clearance at walls and corners. End panels establish the visible finished edge and may affect the final worktop dimension.
When the drawing and site disagree
The correct response depends on the system and the room. Sometimes the sequence, spacing or a non-structural finishing component can be adapted; sometimes the design or supplied part must be corrected. We assess the actual installation rather than forcing a component into a position where it cannot work safely.